How to design stainless steel alcove

1. The thickness of the standard wall exceeds 30cm, and some walls are only 27cm thick, which is also possible. The depth of the niche is recommended to be 15-20cm. If the thickness is shallow, the niche has no practical significance. If it is too deep, the product will not be beautiful.

2. Harmonious ratio Consider the size of the alcove and the ratio of the wall of the shower room.

Generally speaking, the most suitable place is the cleansing side on the left or right, but this cannot be designed into a large size. If a niche is set above the washbasin, the actual size of the groove must be more than 5-10 cm, so as not to affect the work of the bricklayer.

The actual size of the alcove must refer to the floor tiles you choose. The specific size should be the positive ratio of the size of the tiles, and should not be zero difference.

3. For the 45-degree corner design, the shower room is embedded in the alcove. Try to use four frames as a 45-degree surface tension design. You cannot use the yin and yang corners to decorate the design side to show the highest effect of the alcove.

Design effects of three kinds of stainless steel alcoves (1) The whole wall is prominent against the wall, and the floor tiles embedded in the stainless steel alcove are prominent and capped, and some are left concave, and the inlaid stainless steel alcoves Construction conditions of the alcove 1. The wall thickness of the alcove: the thickness of the wall is more than 30cm, and some walls are only 27CM thick, which is also possible. The depth of the alcove is recommended to be 15-20CM. Niches are meaningless. If it is too deep, the product will not be beautiful.